Ed DeVries arrived with his high lift truck. Ed, Howard, Don F. and
others quickly attached chains and then using the high lift truck
removed the left upper door. Ed then loaded the door onto his
equipment trailer and took it to Sparta Sheet metal. Sparta Sheet
metal are the builders of the two new upper doors.
Both doors are not at Sparta Sheet metal for fabrication. The old
doors had far too much sag in them when opened and, after a number
of bracing attempts, the problem could not be corrected. It was
decided that they should be remade and be in good working order for
years to come.
The door is loaded on a truck for transportation to Sparta Sheet for
The front and rear bulk heads will be covered plywood and then
covered with material. Ron, Art and Jerry started cutting the
plywood in preparation of its mounting.
The floors on the lower inside doors continued to be covered with
wood flooring by Jerry, Art and Ed.
Plywood is measured, cut to fit and tacked down.
Mayton, Project Director
4521 Majestic Vue, Zeeland, MI 49464
Tryon, Newsletter Editor
2516 Laurelford Ln., Wake Forest, NC 27587